Newelectronx Reviews, Rating, and Feedback

When I would turn on my nespresso switch on both lights flash 3 times pauses for a second, then flashes 3 more times and continues to repeat this cycle. The troubleshooting section in the manual said I need to look for component failure. I couldn't check the components I didn't even have the key to open the machine. That's when I found you guys. After opening my espresso machine I found a few bad capacitors. After replacing them my coffee machine reset. I'm not done but I should be out of the woods when I close it up. Thanks.

catv-security-tool , haven't used it yet. Took a while longer to receive then receipt said.

Finally was capable to get inside the nespresso machine to fix it. I replaced two blue square capacitors on the electronic circuit board. A successful repair would not have been possible with these tools, especially the oval pan head screwdriver.

In the field we mostly service 3 x 3 x 2 green Outdoor Cable Pedestals. I like to buy these clover tools to unlock Cox telecom pedestals. I've gotten one for most senior members in our company. Since using these I haven't heard any complaints, which is the reason why I'm back to order another few for the rest of my men. I would say Im fairly happy with what I have been provided thus far.

Bought from here the other day. I got a motorola cable box screwdriver bit and a few wholesale Motorola Cable Remote Controls for a lot of dct2000 cable boxes I won in an auction. I would come back and buy here again. The experience and service was worth another buy.

Bought for my time warner cable box, it was missing the plastic lock. on the back of the motorola there is a black hole. i simply pushed the security plastic anti tamper tab in. it sealed up the hole on DCT6412. with the plug back in the hole, the seal is complete. i won't be mistaking for hi-jacking cable when i return the rental equipment.

every 10 times my Krups can make coffee regularly. trying to get it to act right 2 times in a row to get coffee isn't happening. I descaled it with cheap vinegar with no success. Opened it up and check the pressure temp sensors, they seem fine. I opened it and noticed that the little blue capacitor melted. Ordered and replaced them. Also replaced one sensor; everything seems to be back to new.

Not much to comment on... With the CATV tap lock tool it takes a few minutes to block cable ports. The good is that you can pull open a demarc box in minutes. Its travel size to fit in tool bag. I would recommend this cable tv terminator tool.

I purchased several times from your company and I always have good luck. Never had any real problems.

in my case i needed to remove the j key spanner screws from the motorola set top box to perform some repairs. after my tools were delivered quickly i started my project. i was capable of getting off the motorola receiver cover quickly by removing the 7 point security screws. i switch the bit head to a phillips and remove the hard drive. it was all relatively easy with an online manual and the right screwdrivers by my side. thanks.

Allowed me to get into and fix my Motorola dch6200.

bought these to lock and open peds while installing Time Warner Cable Internet outside of the house. there is a rash of low level cable star ped keys. i've used my fair share, and personally stay away from cheap cheap. i like this 8 point star catv tool because it won't fail unless i lose it or someone steals it.

for MDU Apartment Box Enclosures we use SGLR-01 Locking Terminators and Die Cast PICO SS-1D Security Shield Sleeves for taps splitters and filters. Without the rg6 sheild keys, probably half of my daily work wouldn't be possible.