BRAND Units!

Ever try to upgrade a CFT2254 with a 4wire kit or Super Chip without serial programming?

You need the SCG to RE-ACTIVATE it first!

• Intended for the high end Jerrold/GI techs
• This device solves many problems.
• You can INITIALIZE ANY JERROLD/GI including ANY CFT2200 series.
• The Only Activator Capable of Initializing CFT2254/M10/R4 and CFT2100/M10 Series Converters
• Works better than the STICK Mode #4, has new Programming that allows it to un-lock CFT2254/M10/R4 and CFT2100/M10 converters that the STICK will not.
• Allows manual entry INITIALIZATION of Jerrold/GI boxes outside the range of the STICK and RFT!
• You can bring CFT2200's that are SHUTDOWN back to life.
• THIS DEVICE IS A MUST FOR ANY JERROLD/GI TECH!

Features

• Verify functionality of ANY Jerrold/GI analogue box!
• OPEN ANY Jerrold converter even CFT2254/M10/R4 and CFT2100/M10
• TURN ON ANY SHUTDOWN Jerrold/GI box
• It will INIT and Un-lock Jerrold boxes stuck on one channel and remove the notorious Blue screen of death.
• Works where other units FAIL
• THE ULTIMATE JERROLD/GI TOOL!
• Travels with you, works where ever you go!
• NO BATTERY NEEDED TO WORK

What is the SCG and how does it work?

The Service Code Generator requires that you open the converter to use it. It basically works by attaching three wires. Each wire serves a purpose: Data, Ground, and + 5V DC. To eliminate the 9 Volt Battery – one lead connects to the positive and the other to the ground inside the cable box. The last wire connects to the data jumper. The Service Code Generator or SCG is excellent especially when you are already servicing the converter. After the SCG is connected, it’s basically a matter of entering a code. The Service Code Generator will bring any converter back from the dead and allow the full, standard, initial capacity of channels to be available to you. That includes all models from the DP7 to the CFT22XX units.

A few ways to tell your box is dead:

• If the screen reads, “This unit has been deactivated....” or something like that.
• The display on the converter will change from channel to channel or scroll through the available channels, but the station on your TV will remain the same or on one picture – even though you are changing the channel.
• The TV screen is just black or blue, and the channels on the cable box will turn like the previous bullet (above).

If you are experiencing any of the above than you need the Service Code Generator (SCG) to help you get up and running.